
a d v a n c e d i l l u m i n a t i o n . c o m
P u l s a r 7 1 0 M a n u a l
Section: 1.0 Introduction
The Pulsar 710 Controller, used in conjunction with an external 24VDC
power supply, is a compact, 4 channel, high power current source
incorporating a wide range of exibility for selecting the operating
parameters.Theunitcanbeconguredtooperateasastrobeunitora
constant current (DC) source. The unit may be controlled and operated
locally (with some restrictions) or remotely via a USB interface and host
computer.
The balance of this manual contains the necessary operating instructions,
specicationsandotherdetailsrequiredtoallowtheusertoutilizethe
full capabilities of the Pulsar 710.
1.1 Safety
The Pulsar 710 is designed to protect Advanced illumination (Ai) light
headshavingtheSignatechIorSignatechIIlightheadidentication
parameters.WhenusinglightheadsconguredforSignatechI,anadapter
cable must be used to connect these lights to the Pulsar 710.
In certain modes of operation, the output voltages and currents
provided by the Pulsar 710 could result in a potentially injurious
or fatal electrical shock. For this reason, light heads should be
connected BEFORE the power switch is turned on. At no time
should the operator touch the output connector pins when the
power is on.
Advanced illumination makes no warranty, expressed or implied, if
illumination or other devices produced by manufacturers other than Ai
are connected to the Pulsar 710.
1.2 Warranty
Every Advanced illumination, Inc. (Ai) product is thoroughly inspected and
tested before leaving the factory. Products are warranted to be free of
defects in workmanship and materials for a period of TWO YEARS from
the original date of purchase. Should a defect develop during this period,
return the complete product, freight prepaid, to one of Ai’s distributors or
to the Ai factory. Ai will inspect the unit, and if a defect is found will, at our
option, repair or replace the product without charge. Ai disclaims liability
6
d
d
Komentáře k této Příručce